|
|
custom vinyl wraps How to Make Inlays With Vinyl Wrap Film
For perfect color changes, inlays are crucial. Inlays are essential for perfect color change projects. custom vinyl wraps They not only improve the precision of a wrap job by having the vehicle completely covered with vinyl wrap film.
We have included several tips for wrappers who want to make inlays with knifeless tape. These tips will make it easy to create overlays or inlays.
To create an inlay using knifeless tape, the wrapper must first create a template. This will ensure that the final install is precise.
Car Wrapsm
It doesn't matter how many scraps you have - it does not matter what they look like. However, if you stick the pieces together and make sure that their straight edges match the inside edge of your section, you can create the inlay.
Once the pieces have been placed, custom vinyl wraps you can trim the excess material to a point approximately half an inch from the section's outside edge (often in places where there is a line with the body).
This will give you a template to use for your inlay. Now you can carefully remove the inlay from the vehicle's body. To ensure that the scraps don't separate, start by removing it from the original location.
Place the template on top of the material you plan to use for inlay.
When everything is ready, take a sharp blade to cut along the "inside edge" of the template (on top of the material-to-be-applied), custom vinyl wraps which is very important to be precise at this point in order for you to fit the material to the deepest area later.
The "outside edge" is easier. It is important to allow the section to dry for enough time to give it full coverage.
Keep the inlay piece in a safe place until you are ready to apply it.
It is now time to apply the knifeless tape. The line should run along the body line (inner edge) of the area where the inlay should go. custom vinyl wraps To ensure symmetrical cuts, make sure the tape's edge is parallel to the body line. Do not pull on the tape too much, just run it around.
Once you are done, you can take the inlay piece that you have prepared and place it in the section.
You will need to be patient and cautious as you carefully place the "inside edge", so the material fits perfectly, v custom vinyl wraps on the correct spot.
Once everything is in place you can now remove the liner completely.
When you are faced with steep curves, it can be helpful to make relief cuts and apply the vinyl wrap film to the edge of the section. custom vinyl wraps You can heat the film a bit to form it if it has a mild curve.
After the vinyl wrap film has been applied and shaped perfectly, you can remove the knifeless tape from the section. Then, remove any excess material and tape.
These steps will help you create a perfect-formed and cut inlay that fits perfectly into the vehicle's body. custom vinyl wraps You are not far from a paint-like finish!
Installation
TeckWrap
Vinyl wrap
Wrap tips
|
